![]() ![]() Now you have a sharp looking shroud to boost the aesthetics of your rig as well as hide any cables or drives. You can use sticky side velco to fasten it, or just place it in there tightly like I did. Put the finished shroud in place in your PC. Now you should have a nice clean line around your design, and it will look great if you did it properly! Let this coat completely dry and cure a little bit (about a day) and then peel off the tape. This color will be the main color of the piece, unless of course you are doing more than 2 coats, which in that case just repeat step 2. You can see mine at the bottom of this post. If it IS thick enough, and dry, tape off the design you want. iCUE 4000X/4000D/4000D Airflow PSU Shroud Cover Plate, Black 3.99 USD Current price: 3.99. You might need to do another coat of that color if it isn't thick enough. After the first coat it fully dried (I waited a whole night, just let it sit in the house,) check if the paint is see through. Do about 6 passes then let it dry for 4-5 hours (depending on the outside temperature hotter air dries it faster.) Rushing it will only cause your final piece to not turn out as nice. Spray the paint on very lightly and go slow. I have personally looked into the 5' and 7' Raspberry Pi Screens. The size of the cuttout is 150mm x 60mm - however I did just see a build guide on here which had images of actual mesurements which was really well done. Secure the shroud cover with the included screws. I was wondering if anyone has found a perfectly sized sensor panel to put into the pre cut PSU cutout on the side of this case. Hold the shroud cover in place inside of the PSU shroud, lining the top screw holes on the shroud and shroud cover. The color you choose will later be the contrast color of the completed piece. Ensure that there aren’t any large cables or other items blocking the opening of the 570X RGB’s PSU shroud. Clean off the surface of the metal and apply your first layer of paint. You need to be a member in order to leave a comment. The additional fans may also help with GPU temperatures as it is receiving direct flow. Rub the outer surface of the metal with fine sand paper to help the paint adhere. Hey DirtyJerk210, great looking build The most optimal layout with those 2 extra fans would to have them in a pull configuration to move air upwards to your exhaust. While you're there, have them bend and cut a sheet of thin metal following the measurements you made. there is a two-bay HDD cage beneath the PSU shroud that accepts both 3.5 and 2.5 drives on. Go to your local hardware store and buy all of the materials you need. 80 mid-tower with new Corsair fans - can it stand out Dark Theme Light Theme. ![]() > Painters tape (choose your sizes/design) > Spray paint for metal surfaces (choose your color scheme) This price will differ depending on where you live. It is actually really simple, and it only cost me around $20 total. Hey guys! I recently made a PSU/hard drive cover/shroud, and I wanted to share it with everyone, as well as tell you how I did it so maybe some of you can make one too.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |